NOW MEASURE HEAD WEAR ACCURATELY ON EMBEDDED TRACK.
USING YOUR EXISTING GEISMAR TRACK GAGE AND OUR CONVERSION KIT,
YOU CAN QUICKLY BE MEASUREING TOP AND SIDE WEAR ON EMBEDDED RAIL.
BUILT TO ELIMINATE GUESS WORK IN MEASURING WEAR ON EMBEDDED RAIL, YOU CAN NOW
QUICKLY ESTABLISH A BENCH MARK FOR PERIODIC WEAR MEASURMENTS
FORMERY NOT POSSIBLE ON EMBEDDED TRACK.
VARIOUS RAIL SIZE GAGES AVAILABLE. SPECIFY WHEN ORDERING.
STOP THE GUESS WORK, ORDER TODAY!
RRT-760 - HEAD WEAR GAUGE
Part #
Item
Weight
Price
RRT-760
HEAD WEAR GAUGE For Embedded Track
4 lb.
$899.99
KIT INCLUDES:
- 1 SPACER BLOCK WITH BOLTS AND WASHERS
- 1 TAPER GAUGE (ATTACHED BY CABLE)
- 1 HEADWEAR TEMPLATE GAGE(ATTACHED WITH SET SCREWS)
- 1 HEADWEAR TEMPLATE HOLDING BLOCK(WITH ATTACHMENTS)
- 2 ALLEN WRENCHES FOR CONVERSION STEPS
- INSTRUCTIONS INCLUDED
STEPS FOR CONVERSION
REMOVE KNOBS FROM END OF GAUGE WITH 2 KNOBS
WITH WRENCH NOT PROVIDED.
NEXT, FIND SPACER BLOCK AND THE 2 BOLTS
AND WASHERS. ALIGN SPACER BLOCK WITH
HOLES IN GAGE ATTACH TO GAGE.
NEXT, GO TO THE SINGLE KNOB END OF GAGE
AND LOOSEN SET SCREWS WITH ALLEN
WRENCH PROVIDED. REMOVE COMPLETE
ALUMINUM BLOCK. GEISMAR USUALLY
PLACES A SMALL DROP OF GLUE ON BLOCK
WHICH MAY REQUIRE A LITTLE PRYING OF PART
TO REMOVE. BE CAREFUL, ALTHOUGH YOU
ARE DEALING WITH PLASTIC.
NEXT, FIND THE TEMPLATE HOLDING BLOCK
THAT HAS THE TAPER GAGE ATTACHED BY
A CABLE AND THE RAIL TEMPLATE GAGE
ATTACHED WITH SCREWS. WITH THE
INCLUDED ALLEN WRENCH, TIGHTEN
THE SET SCREWS SNUGGLY BUT DO NOT
OVER TIGHTEN AGAIN WE ARE DEALING
WITH PLASTIC. (NOTE THE STICK DOWN
PORTION OF THE RAIL HEAD
TEMPLATE GOES TO GAGE SIDE)
CONVERSION IS COMPLETE FOLLOWING THESE STEPS. YOU ARE READY FOR GAGEING.
